I don't wear baseball caps very often and I don't own many. But I won this one in a contest at Instructables.com so I thought it was fitting that the cap be turned into a project.
Enough background
----------
Two 3.5mm stereo male to stereo male cables were purchased in order to get four 3.5mm ends with cables. The cables were cut 8" (200mm) from the ends. The wires inside were tested for continuity and only the conductors for the sleeve and tip were kept while the conductor for the ring was trimmed short. High power IR LEDs were soldered to the ends of the cables and shrink tube covered each conductor.
3/16" (4.5mm) holes were drilled in the brim of a baseball cap. Plastic ties were inserted into the holes so IR transmitters could be fastened to the brim facing forward. Holes were made in the hat near the temple and rear of the hat by pushing a scratch awl through the material. A large diameter nail would also work so long as it tapered gradually,. The IR LEDs were pushed through these holes then glued in place.
To do:
The rest of the posts for this project have been arranged by date.
Enough background
----------
Two 3.5mm stereo male to stereo male cables were purchased in order to get four 3.5mm ends with cables. The cables were cut 8" (200mm) from the ends. The wires inside were tested for continuity and only the conductors for the sleeve and tip were kept while the conductor for the ring was trimmed short. High power IR LEDs were soldered to the ends of the cables and shrink tube covered each conductor.
Cables and LEDs
LED soldered to cable
Completed LED cables
3/16" (4.5mm) holes were drilled in the brim of a baseball cap. Plastic ties were inserted into the holes so IR transmitters could be fastened to the brim facing forward. Holes were made in the hat near the temple and rear of the hat by pushing a scratch awl through the material. A large diameter nail would also work so long as it tapered gradually,. The IR LEDs were pushed through these holes then glued in place.
Plastic ties and hat brim
Scratch awl pushed through cap
LED pushed into awl hole
Four LEDs in hat
Gluing LEDs into hat
Right front side of hat
Right rear side of hat
Rear of hat
To do:
- Test
Journal Page
The rest of the posts for this project have been arranged by date.
A list showing of all the final posts of COMPLETED projects.
Disclaimer for http://24hourengineer.blogspot.com/
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All
information in this blog, or linked by this blog, are not to be taken
as advice or solicitation. Anyone attempting to replicate, in whole or
in part, is responsible for the outcome and procedure. Any loss of
functionality, money, property or similar, is the responsibility of
those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes
the intellectual property of Brian McEvoy. Any information contained
within these messages may be distributed or retained at the discretion
of Brian McEvoy. Any email sent to this address, or any email account
owned by Brian McEvoy, cannot be used to claim property or assets.
Comments
to the blog may be utilized or erased at the discretion of the owner.
No one posting may claim claim property or assets based on their post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2014-11-17 (Su)
2014-11-17 (Su)
Comments
Post a Comment