2015-01-21 (W) Color/Touch + Sound

Small wood screws were put into the bottoms of the enclosures to elevate them slightly. This was to keep them from sticking to paper while paint was drying. The screws were not given pilot holes or put in deeply. These are meant to be removed after painting and leave inconspicuous holes.

Elevating screws

A layer of paint was applied with an ordinary bristle brush. The same paint as the first prototype was used although this paint was darker and less of a neutral gray than desired.

Painted enclosures

To do:
  1. Paint enclosures
  2. Plot out location of all lights for even distribution
  3. Create circuit board
    1. Designate all components
    2. Design schematic of components
    3. Design layout for single layer board

Journal Page

The rest of the posts for this project have been arranged by date.

A list showing of all the final posts of COMPLETED projects.


This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.

All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.

All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.

Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim claim property or assets based on their post.

This blog, including pictures and text, is copyright to Brian McEvoy.

2015-01-15 (Th)

Comments