2014-11-21 (F) Arduino Laser Tag

A draft was made with the measurements of the screen and breakout board. The intention was to tape the cutout to the plastic before painting so a window would remain free of paint. Double-sided tape was not available so electrical tape pieces were cut into the screen's dimensions and put on the plastic over the screen area. Paint was applied to the tape side while the other side remained covered in its shipping tape. The paint was allowed to dry overnight in a heated garage.

 Drawing under plastic sheet

Tape covering screen area
Painted plastic covers

To do:
  • Draft schematics
  • Break down tasks further
  • Build vests
  • Build another tagger
  • Make instructions for all parts


Journal Page

The rest of the posts for this project have been arranged by date.

A list showing of all the final posts of COMPLETED projects.


This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.

All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.

All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.

Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim claim property or assets based on their post.

This blog, including pictures and text, is copyright to Brian McEvoy.

2014-11-19 (W)

Comments