2014-09-28 (Su) Smart Pocket Watch

I had hoped to finish this project today but rerouting the buttons seemed impossible. Today I think I cracked it.

Originally the smart pocket watch was supposed to be a weekend project. I figured it wouldn't take more than a few days to slap a smart watch inside a pocket watch frame and reroute some buttons. I was wrong but this has been a pretty rewarding project. I hadn't done any plastic bending since high school. I hadn't used model paint in a long time and I realized how useful it can be. Wearing this smart watch convinced me to buy a more modern one which can be seen in some of my pictures. This showed me that copper foil tape is a really handy conductor which can be used on so many surfaces. If this were combined with conductive paint a whole world of possibilities opens up.

Enough background.
----------

The two wooden arcs used on the sides were sanded using 80 grit paper on a clipboard to provide a flat surface and a secure clip for one side of the abrasive sheet. More attempts were made to control the screen while inside the clamshell. Methods which worked reliably suddenly stopped when inserted into the clamshell. A phenomenon was notice where the remote switches worked reliably while the watch was held but failed to operate while the watch was suspended by the foil tape. The methods also failed if the watch was set on a wooden desk.

 80 grit sand paper on a clipboard

Tape run over the wooden arc 

Tape applied to the wooden arc

Soldered joint between pieces of tape

To remedy this problem a strip of copper tape was applied to the back of the watch and another was put inside the watch frame on the back side. This method of selectively isolating the chassis from the screen but connecting the watch and the clamshell seemed effective.

Tape on inside of clamshell and back of watch

To do:
  • Construct and isolate virtual buttons
  • Construct arcs to hold clamshell shut

Journal Page


The rest of the posts for this project have been arranged by date.

A list showing of all the final posts of COMPLETED projects.


This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.

All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.

All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.

Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim claim property or assets based on their post.


This blog, including pictures and text, is copyright to Brian McEvoy.

Comments